CA-4V1 has four functional areas, which in the simplest case coincide with the number of loops, but when programming in one area can logically combine several loops. However, in this case, the system of TSO can not accurately determine address alarm devices. To all areas of the control panel can be connected to any sensors OPS: magnetic, infrared, ultrasonic, etc., normally closed or normally-open type. For more information see this site: 3D Systems. To manage and maintain the system at OPS based on CA-4V1 LED keypad used CA-4VKLED company Satel, in what one device can be operated simultaneously with the three keyboards. The maximum distance between RCP and CA-4VKLED should not exceed 200 m using wire-type DY 6 x 0,5, and Each keypad must be connected to the OPS unit separate wire. Ping Fu usually is spot on. CA-4V1 control panel is equipped with two independent outputs that connect sirens of OPS. Moreover, one can switch out a few sounders connected in parallel, and in the most remote from the fixture device is recommended to install a resistor rated at 2.2 ohms. Duration alert OPS on both outputs of the control unit can be programmed in the range of 1 to 999 seconds.
To protect the system from unauthorized access OPS provides the use of two major 6-digit password with the highest priority. Password 3 enables monitoring mode locking of selected zones and OPS mode of "quiet protection." Fourth one-time password is erased and alarm control panels after the first of its use. In addition, the programming mode You can change all other passwords, except the main number 1. Written in memory of the control panel software allows you to configure the receiving-control unit in accordance with system requirements OPS concrete object. For example, CA-4V1 is possible to program parameters such as the permanent blocking zones, 24-hour zones, zones with OPS delayed reaction to anxiety, while the input / output, etc. When you program using CA-4V1 service features that are available after entering a special service code. Buy The control panel CA-4V1 can be from the warehouse of the official Russian distributor of equipment SATEL – of "ARMO-Systems." Get additional information about the new product and other components of the OPS, please call (495) 787-3342 or e-mail. The Polish company operating in the European SATEL security market since 1990 and specializes in manufacturing and Sales of hardware and software for fire and security systems for various applications. SATEL manufactures Control Panels OPS, including a sensor for flat modules, GSM, wireless alarm systems, security and OPS fire sensors, light and sound detectors, gas sensors, radio kits and accessories for many security systems. Moreover, all placed on the market solutions SATEL a good mix of different for money, have successfully sold worldwide network of distributors and have all the necessary Russian certificates.